You can put a cover over a basement egress window well, but it must not block the exit. The International Residential Code (IRC) section R310 requires covers, grates and screens over an escape opening to release or remove from inside without a key, tool, special knowledge or extra force. CoverUp covers are built to open from inside.
What does the building code say about basement egress?
The IRC requires emergency escape and rescue openings in basements with habitable space and in sleeping rooms. In plain terms, if people live, work or sleep downstairs, there has to be a way out other than the stairs, and a way for firefighters to get in. For a basement below grade, that opening is usually a window set in a window well.
How big does an egress window well have to be?
Under IRC section R310, a window well that serves an escape opening has to meet a few basic requirements:
- The well must let the window open fully.
- It must provide a minimum clear area of 9 square feet, with at least 36 inches in each horizontal dimension.
- A well deeper than 44 inches needs a permanently attached ladder or steps so someone can climb out.
These rules are about the well and the window. The cover is a separate question, and it has its own rule.
Can you put a cover over an egress window well?
Yes. The code does not ban covers. It says that bars, grilles, covers or screens placed over an escape opening must be releasable or removable from the inside without a key, a tool, special knowledge, or more force than it takes to operate the escape opening itself. A cover that is bolted down, padlocked or too heavy to push open fails that test. A cover that a person in the basement can release and push aside passes it.
How do CoverUp covers open from inside?
Our covers are attached to the well only, never to the house. That is deliberate: the cover has to be completely removable in an emergency. We use one of two mounting methods:
- Stainless steel clips: the cover opens from inside or outside. Push on it and it unclips.
- Interior locking system: the cover opens from inside the well only, by pulling a pin out of each lock. It cannot be lifted off from the yard.
Our standard egress window well cover is built around quick release. It is strong enough to stop falls and keep debris out, but light enough to push open during an escape. Like all of our covers, it uses Lexan polycarbonate over aluminum cross supports and holds up to 800 lbs.
Is a locking cover still safe for an egress window?
A locking cover keeps people out from the yard side while still opening from inside the well. Because the lock releases by hand from below, the cover stays removable in an emergency. Both of our mounting options, clips and interior locks, are designed to meet safety and building-code standards. During installation, the installer checks that the cover releases easily wherever egress is required.
Does a deep egress well need a ladder?
Under the IRC, a well deeper than 44 inches needs a permanently attached ladder or steps. A cover does not replace that ladder. We offer basement window well escape ladders as an accessory, and for new egress wells we install deeper, code-compliant wells with built-in ladders. Browse ladders, locks and other add-ons on our accessories page.
What should you check before covering an egress well?
- Which basement rooms use the window as their emergency exit, especially bedrooms.
- That the well gives the window room to open fully and meets the clear-area minimum.
- Whether the well is deeper than 44 inches and has a permanently attached ladder or steps.
- That the cover releases from inside by hand, with no key or tool.
- That everyone who sleeps downstairs knows how the release works.
Our window well cover installation page explains how we measure, build and test each cover, including the egress check.
Do local codes differ?
Yes. Local codes vary, so check with your local building department before you finalize egress wells and covers. The IRC is a model code, and your city or county decides what applies to your home. If an inspector asks a specific question about your cover, we are happy to explain how it mounts and releases.
Egress Window Well Cover FAQ
Will my window well cover pass inspection?
We build covers to be removable from inside, which is what the IRC asks of anything placed over an escape opening. Inspection decisions belong to your local building department, so confirm their requirements for your home.
Can children open the cover from the yard?
A clip-mounted cover opens from inside or outside with a push. If you want a cover that cannot be lifted from the yard, choose the interior locking system, which opens from inside the well only.
Do I need to be home for the installation?
No. All of the work is done outside, and the covers are made inside our work trucks. We only need access to your yard and an outdoor electrical outlet. Contact us or call 888-267-4242 to schedule.
Where we install
- Window well covers in Denver
- Colorado service area
- Midwest service area
- Custom window well covers
- Cover installation
- Get a free estimate
